Questions tagged [flyingbear-ghost-4]
5 questions
4
votes
1 answer
Why is some part of the print not aligned?
I'm using a Prusa Slicer with a FlyingBear Ghost 4 and got a wrong printing alignments on the Y axis only on a part of the printing object. What may cause this?
Here are the printed model pictures showing the problem:
Here are the settings:
#…
Eric Brochu
- 245
- 1
- 7
3
votes
3 answers
Passing from nozzle diameter 0.4 mm to 0.2 mm causing filament jamming in heater
Im using Prusa Slicer 2.1 for my FlyingBear Ghost 4.
I just changed my 0.4 mm nozzle for a 0.2 mm but it seems to jam in the heater probably due to too much filament trying to get out by the nozzle. Where is the setting to reduce the filement speed…
Eric Brochu
- 245
- 1
- 7
3
votes
0 answers
Horizontal defects when linear_advance enabled?
What could cause that?
When linear_advance (v1.5) is "off" (M900 K0) - everything is uniform and smooth, only corners are protruding as expected.
When it is "on", I get these horizontal defects. My calibrated K-value is 2, I am getting same…
BarsMonster
- 71
- 1
- 8
2
votes
1 answer
PLA does not stick to center of the bed anymore
I have used my printer (Flying Bear Ghost 4) for the last year and a few days ago I noticed that the center of the heat bed does not stick like it used to.
I think it can be caused by the fact that I always print at the center of the bed (glass) and…
Eric Brochu
- 245
- 1
- 7
0
votes
0 answers
Bottom part of spherical objects print problematic
I got a Flyingbear Ghost 4 and using Cura. It is doing fine until I have to print spheric things. I'm using a high density material that needs to be at 210 °C and slower print speed. I also built a top and a door for my printer so it's partly…
Eric Brochu
- 245
- 1
- 7