2

I have used my printer (Flying Bear Ghost 4) for the last year and a few days ago I noticed that the center of the heat bed does not stick like it used to.

I think it can be caused by the fact that I always print at the center of the bed (glass) and the center is now too much used.

Is there a way to fix it or will I need another bed?

0scar
  • 32,029
  • 10
  • 59
  • 135
Eric Brochu
  • 245
  • 1
  • 7

1 Answers1

1

Actually I washed my heat-bed with some dishes soap and dried it very well, releveled it and now all is fine. I guess it was greasy even if i cleaned it as usual.

Eric Brochu
  • 245
  • 1
  • 7