Questions tagged [dremel-3d45]
8 questions
2
votes
0 answers
ABS does not stick AFTER some good layers
Usually I had problems with the adhesion of the first layers, and most questions here and out there are about this issue.
Instead now I'm facing another problem. After "some" (few or even after 10h) suddenly the filament does not stick anymore to…
Mark
- 199
- 7
2
votes
1 answer
How to fix these issues with Nylon?
I'm using Ultimaker Cura and a Dremel 3D45S with an eSun Nylon filament.
As starting point I'm using the default settings of the printer, 260 °C for the hotend and 80 °C for the bed.
These are the results:
In addition to the poor print quality,…
Mark
- 199
- 7
2
votes
2 answers
Under-extrusion halfway into print - Dremel 3D45 -PETG
NEW UPDATE BELOW
I am having trouble finding the cause for this under-extrusion at start/end of each layer.
Something changes halfway into the print creating a visible seam at some specific layer height.
This also creates dimensional inaccuracy…
rosi97
- 121
- 3
1
vote
1 answer
eSun Silk Rainbow PLA leads to nozzle clogging
I use eSUN (Silk) PLA filament daily and I've never had an issue. I use the parameters suggested by the manufacturer:
nozzle temperature: 210 °C
bed temperature: 60 °C (with purple glue)
The extrusions are perfects (the printing itself may be…
Mark
- 199
- 7
1
vote
1 answer
Why raft is printed much better than the actual first layer?
I'm facing a weird problem I cannot understand why it happens.
Most of my objects have a large planar base so I don't have any adhesion issue.
I'm using a PLA Silk gold filament from eSun (filament dryer is on while printing) and a Dremel 3D45…
Mark
- 199
- 7
1
vote
0 answers
Dremel 3D45 does not honor temperature settings
I set:
G-code override: false
filament: PETG
nozzle temperature: 245 °C
Here the pictures that state the above points:
When loading the model, it also confirms the nozzle temperature of 245 °C:
But when running, it uses another temperature…
Mark
- 199
- 7
0
votes
3 answers
No way to stick PETG on buildplate
I did my homework reading similar questions, like this, this and this.
Here a video that shows the issue:
The filament is PETG from JAYO and the printer is a Dremel 3D45.
As you can see, the filament does not stick on the buildplate. The…
Mark
- 199
- 7
0
votes
0 answers
What is the thread pitch of a Dremel 3D45 nozzle?
I can't find this information in the official docs. To buy a new nozzle I should know the pitch of its thread.
I'm aware I can guess its size "measuring" it with a caliper, but since it's a specific feature of a commercial product I wonder if it's…
Mark
- 199
- 7