Questions using this tag should involve the FLSUN QQ 3D printer that is manufactured by FLSUN
The FLSUN QQ is a FDM/FFF 3D printer manufactured by FLSUN.
Questions tagged [flsun-qq]
5 questions
8
votes
1 answer
How to change the voltage on a FLSUN QQ
I just bought a FLSUN QQ and the instructions say I need to change the voltage from 220 to 110. Sadly the instructions don't say how to do that. Can anyone tell me how to do it?
linuxdan
- 1,289
- 11
- 27
2
votes
2 answers
How can I print to my FLSUN QQ over Wi-Fi?
I want to be able to control my FLSUN QQ over Wi-Fi and don't have OctoPrint or a Raspberry Pi to run it on.
linuxdan
- 1,289
- 11
- 27
0
votes
0 answers
How can I improve dimensional accuracy of a delta printer?
I have a delta printer that I am trying to fine tune. I have printed a 20mm calibration cube and I get the following measurements:
X: 20.5
Y: 20.3
Z: 20.0
How can I calibrate my printer to improve the accuracy of x and y ?
linuxdan
- 1,289
- 11
- 27
0
votes
0 answers
Under-extrusion near the seam
I have an FLSUN QQ-S Pro and I'm trying to print a part consisting only of thin walls with PLA. I'm using Cura 4.8.0, "FLSUS QQ-S" profile. Unfortunately, near the seam there are signs of underextrustion. It only happens near the seam, and after a…
Vladislav Ivanov
- 101
- 4
0
votes
1 answer
FLSUN QQ doesn't print and stops at Z=15 mm
When I try to print something that is not the test model already on the SD, which means when I try to slice something in Cura 4 and than I start the print, the nozzle stops at Z=15 mm and only the extruder motor goes foward and backward. I tried to…
Valeri 0S
- 37
- 4