Questions tagged [bridging]

Don't support bridge is a good idea to reduce support with acceptable print quality. But in this case, if I have a very long bridge and a short bridge, how do I tell the slicer to generate support only for the long bridge. How can I set some…

I'm trying to print this model of a boat: It has 2 keels joined by 5 bridges, but the top of each keel is curved, so while the middle part is mostly flat, the bridge on the back has a bit of a slope (as you can see with the "stair" effect). The…

I'm printing small detail on Prusa Mini with Prusament PLA @ default 215 °C. Model was sliced with the PrusaSlicer with default 0.15 mm quality profile. The problem is that when the printer is making the bridging infill it does not stick it properly…

When I have overhangs in my model, Cura colors them red. However, I noticed if I make layer thickness thinner, the red area is reduced or disappears. This could mean that thinner layer thickness is better for overhang, but it could also mean that a…