Questions using this tag should involve the Tronxy X1 3D printer manufactured by Shenzhen Tronxy Technology Co., Ltd.
The Tronxy X1 is a printer of the X Series of FDM 3D printers manufactured by Shenzhen Tronxy Technology Co., Ltd.
Questions tagged [tronxy-x1]
5 questions
5
votes
4 answers
Can 3D printers, such as a TronXY X1, handle 24/7 projects?
I have an incoming project and the only 3D printer available to me is the TronXY X1.
So the question is: Can it handle at least four days of continuous load or should I search for an alternate solution?
I don't want to damage (my only) 3D printer…
Apollyon
- 81
- 3
4
votes
2 answers
Ramps 1.4 with a power brick
I'm currently designing a RepRap 3D printer that will not have a heated bed. I have heard that it is possible to use a power brick with commercial printers lacking heatbeds. Is this possible with a RepRap printer using a RAMPS board?
I'm referring…
TECTEC3 Studios
- 416
- 2
- 6
3
votes
1 answer
Artefacts when printing parallel to X axis
If you can help me with troubleshooting the artefact shown in the attached photo that would be great. It only happens when I print the Benchy parallel to the X axis and when I print parallel to Y axis it prints just fine.
Notes:
3D printer: TronXY…
Apollyon
- 81
- 3
1
vote
1 answer
TronXY X1 Configure bed offsets
I have this printer with the 1.1.6 Marlin. The issue with it is when the printer starts printing the position of the hotend is offset
I am using Cura as the slicer. There, I tried this G-code to configure offset
G28 ;Home
G1 Z15.0 F6000 ;Move the…
mr.M
- 111
- 1
0
votes
0 answers
Prints are Squished
My printer prints stuff okay but its all squished and much shorter than the model, My z Axis Esteps is fine I checked for loose wires and overheating but I can't figure it out. My Temp is 195, .15 Layer Height, PLA, Marlin Firmware
Bodhi Teraguchi
- 31
- 4