3D Printing Stack Exchange
3D Printing Stack Exchange

Questions tagged [creality-ender-4]

For questions about the Creality Ender 4 3D printer

The Ender 4 is a low-cost DIY 3D H-bot printer using aluminium profiles (20 x 20 mm and 20 x 40 mm) creating a cubic printer frame. The series are equipped with a heated bed and a Bowden style extruder. The build platform is lifted by a single Z-axis stepper motor.

6 questions
5
votes
2 answers

Creality Ender 4 extruder problem

I cannot get my extruder to work on my Creality Ender-4 printer. I have heated the nozzle but the extruder does not move. I tested the motor and cable on another system and they work just fine. Could it be the board or what could it be?
Jens Thomsen
  • 171
  • 3
5
votes
1 answer

Problem with print bed height on Creality Ender 4

I am a novice to 3D printing and have encountered an issue that I cannot seem to solve. Hopefully someone here can point me in the right direction. I have a Creality Ender 4 that I purchased a few months ago and up until about 4 weeks ago, it worked…
dusodesign
  • 51
  • 3
4
votes
2 answers

How to calibrate Ender-4

I have just assembled the Creality3D Ender-4 kit a couple of days ago. I completed some rewiring and everything seems to be wired correctly, I'm able to auto-home successfully, but this is the problem I'm having: I tried printing a calibration cube.…
Chepech
  • 163
  • 1
  • 5
3
votes
0 answers

Ender 4 problem with printer stopping mid print

I'm looking for suggestions to what might be causing my prints to stop mid print. I slice with Ultimaker Cura 3.6. Some prints work fine and others randomly stop at different heights for no apparent reason; they are not getting stuck, hung up or…
MeliJoe
  • 31
  • 2
2
votes
3 answers

Creality 3D Ender-4, a "extruder kit" does not fit the frame

This is my first time building a 3D printer (a "Creality Ender-4"). Everything is going fine except the "extruder kit" part that does not have enough space to attach on the frame. Should I drill it to have a longer hole so it can be attached to the…
KoKo
  • 123
  • 5
0
votes
0 answers

The bed of my Ender-4 does not go down during printing!

I am using an Ender-4 with MKS Marlin Firmware and an MKS Rovin V3 Motherboard. It took me a long time to get Marlin set up correctly, but now I am apparently on the way. I calibrated the bed and to test it I went to print the cube_XYZ, I noticed…
Levy Cruz
  • 1
  • 1