Questions tagged [skr-cr6]
2 questions
2
votes
1 answer
Raising E-steps on my CR-6 SE makes the extruder choppy
I have the community edition of the firmware for my CR-6 SE printer installed on a BigTreeTech SKR-CR6 V1.0 board. This firmware has a nice E-step calibration guide you can use to easily get the correct step/mm value.
However when I raise that…
inifus
- 35
- 7
1
vote
1 answer
Weird pattern on vertical surfaces on all prints
I recently received my Creality CR-6 SE printer and upgraded the controller board to a Bigtreetech SKR CR6 V1.0 and installed the latest community firmware.
As you can see on the attached image, the corners have this weird elephant foot thing going…
inifus
- 35
- 7