3D Printing Stack Exchange
3D Printing Stack Exchange

Questions tagged [flsun-3d-cube]

6 questions
3
votes
2 answers

Main board heated bed connectors aren't powering up

Flsun 3D Cube; Marlin 1.1.1; main board: Makerbase MKS Gen_L V1.0; running from either Repetier or OctoPrint. I was recently obliged to replace the main board when it stopped powering the heated bed. I got the new main board - same make, version,…
Bill in Kansas City
  • 223
  • 1
  • 7
2
votes
1 answer

mjpg_streamer, Octopi, Kubuntu

Running my Flsun 3D Cube from a Kubuntu PC using Octopi, and trying to get my webcam to work with it. I've followed the instructions on Github for mjpg_streamer to the letter. Everything I've read says, "Sure! The Raspberry PI directions will work…
Bill in Kansas City
  • 223
  • 1
  • 7
2
votes
0 answers

Upgrade main board or straight-across replace?

Flsun 3D Cube; main board, MKS GEN L V1.0 I think I need to replace the main board and I don't know enough about 3D printer components yet to judge whether a 1:1 replacement would be better than selecting a different board, or keep the same board…
Bill in Kansas City
  • 223
  • 1
  • 7
2
votes
1 answer

Marlin 1.0 works: Marlin 2.0 destroys Z-axis motion

I have an FLSun 3D Cube, running off an MKS GEN V.1.4 main board. With Marlin 1.0, the Z-axis works great (and has been for three years). When I try to upgrade to Marlin 2.0, moving the Z-axis 10 mm results in extreme motion -50 mm at least, left…
Bill in Kansas City
  • 223
  • 1
  • 7
1
vote
1 answer

Re-homing Z: trouble resuming a print, what if I can't re-home?

Running Marlin 1.1.2, printing from Octoprint on Linux PC. So, the PC freezes up and I have to pause the print and reboot. It's a 36 hour print with 11 hours left to go and I'd rather not start over. I have the X, Y, and Z coords of where I need to…
Bill in Kansas City
  • 223
  • 1
  • 7
0
votes
0 answers

What firmware type to use for FLSUN 3D printer in PrusaSlicer setup?

I have a FLSUN printer: 3D Printer DIY Kit Auto Leveling Cube Full Metal Square Large printing size 260X260X350 with heated Bed Precision. I plan on using PrusaSlicer as slicer (found it in Ubuntu.) I now need to pick a Firmware Type in the setup…
MeSo2
  • 131
  • 4