Questions about the 3D printer controller board, the MightyBoard
The MightyBoard is a DIY Open Source 3D Printer Controller Board based on the Arduino Mega platform designed by MakerBot for their Replicator 3D printer. More details here.
Questions tagged [mightyboard]
4 questions
9
votes
1 answer
MakerBot Replicator 1 Voltage Regulator Fix
My Replicator (you know, the one made of balsa wood) has blown a voltage regulator on its MightyBoard for the second time. The first time, MakerBot graciously replaced it. However, they replaced with the same model board with no apparent fix for the…
tbm0115
- 6,234
- 2
- 18
- 40
6
votes
2 answers
Power Supply Safety
I just recently purchased a new MightyBoard (Rev G) for my Replicator that requires a new power supply.
The power supply for the Rev E was a 24 V/9.2 A which was necessary for the dual extruders and heated bed. I know I need a 24 V power supply,…
tbm0115
- 6,234
- 2
- 18
- 40
4
votes
3 answers
Can't control printer via USB
I've recently purchased a Makerbot Replicator Dual clone made by CTC. I'm in the process of upgrading/adding a few parts to it, but noticed that I can't control or print via USB.
The machine prints perfectly from an SD card and I can see information…
AvieRose
- 143
- 5
2
votes
1 answer
What is the MightyBoard 1280 IO used for?
While I've worked on fixing my voltage regulator on my MightyBoard, I've noticed an extra set of pins available labeled Atmega 1280 IO. I've tried finding documentation on what these pin can be used for to no avail. I'm curious if there is any use…
tbm0115
- 6,234
- 2
- 18
- 40