Can anyone tell me where to connect a cooling fan on the Sanguinololu v1.3a board? A few of the information pages mention three PWM outputs: Extruder, bed heater and fan, but none of the wiring diagrams that I can find, actually show the connections for the fan.
Asked
Active
Viewed 403 times
1 Answers
4
It appears that there isn't an "out-of-the-box" solution to your request, but luck is with you. Someone with your board and objective has posted what appears to be a reasonable modification:
http://www.instructables.com/id/Add-a-Cooling-Fan-to-your-Rep-Rap-Sanguinololu/
fred_dot_u
- 10,532
- 1
- 10
- 24
-
Yes, this confirms what I was beginning to think and it is a mod I can handle. Thanks. – typhonic Jul 19 '16 at 21:14