Wii U GamePad Outer Case Replacement

Written By: Valentina Cerruty
  • Comments: 12
Wii U GamePad Outer Case Replacement

Difficulty

Easy

Steps

5

Time Required

4 - 7 minutes

Introduction

This guide will help you to remove the outer case and be able to open the Nintendo Wii U Gamepad. You will need a Tri-WIng Y1 screw driver.

  1. dKTaxZjIUAsyAXlI

    • Place Gamepad face down and remove the two 4.7 mm screws with a Phillips size #00 screwdriver.

    tried to unscrew the 10 Tri-Wing size Y1 screw with my iFixIt toolkit

    unfortunately the tool is too “fat” and short, it cannot reach 4 screws on the corners of the gamepad.

    having the iFixIt toolkit and needing to purchase an additional slim screwdriver it’s a shame…

    Antonello Iannone -

  2. jQnDZvXRQvPOXfpG

    • Lift and remove the battery plate.

  3. qZN3PgyACtZ5Tw4i
    qZN3PgyACtZ5Tw4i
    nDakTZouVNlkKPKx
    o4RQ44lFuusIk4uU

    • With your finger, press down and pull back on the battery connector plug.

    • Remove the battery from the battery case.

    Battery lifts up from the bottom not the top like the photo shows.

    Tyler Schommer -

  4. IlOVIxDuCaqAuWCO
    IlOVIxDuCaqAuWCO
    iNj1oAZjk4bbQA1g
    CfComIPOOBMDkYhT

    • Remove 10 9mm screws with Tri-Wing size Y1 screwdriver around the outer case.

    • Lift up on the back of case.

    • Lift gently because the rumble motor in the back of the case is still connected by a cable to the motherboard.

    I used a small blade tip to life up on the black squares that covered the screw holes. Replacing them after.. I skipped that as it seemed impossible they would even stick back down.

    Chris -

    I am having trouble getting the two screws on the hand grips as the screws are too deep. What should I use to get them?

    Essma -

    I ended up having to buy some cheap amazon screwdrivers and are very disappointed

    Essma -

  5. MBTkFeprlTH425NV

    • Unplug outer case rumble motor connector from the motherboard with your fingers.

    Do not pull by the wires! If you do, you better be pretty good at soldering.

    Brandon -

    I agree. A circle over the plug would have been better as the picture looks like you just pull on the wires lol.

    Chris -

    Thanks for the comment. I did get a set of tweezers and the negative cable broke anyway. They really could have done a better job at using a different connector for that.

    Kristen Bartholomew -

    Great. Didn't pull on cord. Whole thing ripped off.

    August -

    Why in the world is this thing so tightly connected?

    Andrew Moore -

    Thanks for the comment. I did get a set of tweezers to try to pull it out but still ended up breaking the negative cable. They really could have used a better set of cables and connectors for this.

    Kristen Bartholomew -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Valentina Cerruty

Member since: 10/02/16

3045 Reputation

One comment

This doesn't show anything about taking the front of the housing off, is that relatively straightforward?

Will Prosser -