HP Spectre x360 13-ac023dx Battery Replacement

Written By: Dylan Beery
  • Comments: 3
HP Spectre x360 13-ac023dx Battery Replacement

Difficulty

Moderate

Steps

3

Time Required

10 minutes

Introduction

If your HP Spectre x360 13-ac023dx laptop is overheating or is having trouble charging properly, use this guide and follow it to replace the battery.

  1. 1MhkVSDsny3TRWKG
    1MhkVSDsny3TRWKG
    eRH63AJPBF1ptHMb

    • Flip the laptop over so the model sticker faces the ceiling.

  2. JupkD6Zp6H3oNlbi
    JupkD6Zp6H3oNlbi
    T41fwcLomOIKvMQ1
    RGJjuJhSoQWBIdke

    • Use a Torx #5 screwdriver to remove the six 3.5 mm screws holding the back cover to the laptop.

  3. qLEJDnAKgHKcl5jJ
    qLEJDnAKgHKcl5jJ
    xJPapt5LQDGWUPoW

    • Use the Phillips #000 screwdriver to remove the four 3.5 mm screws holding the battery.

    • After removing the screws, detach the battery wire from the mother board with the iFixit opening tool.

    • Then, carefully lift the battery off with the iFixit opening tool.

    Need to provide a direction in step #1 about removing the rubber pads and accessing the two screws at the bottom.

    David McCurry -

    Second that. What's the best way to remove the feet?

    Oskar Petersons -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Dylan Beery

Member since: 21/10/19

272 Reputation

One comment

The overall procedure is ok, however as others commented instructions on how to remove the feet would be helpful. I tried a heat gun to help loosen the glue, however that just melted the feat. Overall go the job done, but 2 out of the 4 feet were destroyed in the process.

Also in my case there were no screws under the top or bottom feet, so I could have probably removed the cover without removing the feet.

Joseph Ficara -