GameSir T4 Pro Sticky Buttons Replacement

Written By: Madison Puckett
  • Comments: 0
GameSir T4 Pro Sticky Buttons Replacement

Difficulty

Moderate

Steps

9

Time Required

15 minutes

Introduction

This guide will help you repair the sticky buttons on your GameSir Pro T4.

Sticky buttons often happen due to the build-up of dirt in the button's crevices.

  1. EKYDuOuhGH3IVs2m

    • Using the Phillips 1 screwdriver, gently turn the screw to the left (repeat this step until all four screws are taken out).

  2. Z253w1hw1YAOjJxm

    • Use your iFixit opening tool to break the seam of the back of your controller.

    • Be careful when pulling apart, as the charging port wires are connected to both sides of the controller.

  3. jUg1fYhBZi5jeRCv

    • Using the plastic spudger, wiggle the connection out of place.

  4. eFTIEf6Ls2hFPq6f

    • Apply a slow, but consistent pull to the old 600 maH battery.

    • Attach new battery onto the pad

  5. ECKxEXQ4p4EdGgNl
    ECKxEXQ4p4EdGgNl
    pBQuGGlOQOh3VPRt

    • Remove the three 5mm screws on the motherboard.

  6. HYMSQQMK5lwPMEM3

    • Disconnect all white connectors from the motherboard.

  7. DlIYDZlKnuV2EC1i

    • Carefully pull the motherboard away to reveal the front panel.

  8. BBFLmFF4IFQ1dSpE
    BBFLmFF4IFQ1dSpE
    aJsuVRniWcUlYBIN

    • Remove the white rubber panel to get access to the buttons.

    • Put a small dab of alcohol on your cotton ball and clean around the area of your sticky button.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Madison Puckett

Member since: 16/09/22

680 Reputation

0 comments