CHI Spin N Curl Rotating Curler Motherboard Replacement

Written By: Annalise White

Comments: 0

CHI Spin N Curl Rotating Curler Motherboard Replacement

Difficulty

Moderate

Steps

Time Required

30 - 45 minutes

Introduction

If your CHI Spin N Curler Rotating Curler is not turning on, but the power cord is still intact or you've already replaced it, follow these steps to replace the motherboard.

Tools

Step 1

Use a metal spudger to pry off the silver, shiny trim.

Step 2

Remove inner black housing of the CHI Spin N Curl using the metal spudger to pop it out.

Step 3

Use a 2 mm flathead to remove the two screws.

Step 4

Use a metal spudger to pry open the seams of the device.

Step 5

Toward the bottom of the device, grab the swivel power cord.
Gently pull the power cord to detach it from the CHI Spin N Curl
Replace the faulty cord when the original cord has been removed.

Step 6

Use a metal spudger to pry off the silver, shiny trim.

Step 7

Remove inner black housing of the CHI Spin N Curl using the metal spudger to pop it out.

Step 8

Use a 2 mm flathead to remove the two screws.

Step 9

Use a metal spudger to pry open the seams of the device.

Step 10

Toward the bottom of the device, grab the swivel power cord.
Gently pull the power cord to detach it from the CHI Spin N Curl
Replace the faulty cord when the original cord has been removed.

Step 11

Use a Phillips #00 screwdriver to remove the screws holding the barrel in.

Step 12

Remove the screws using Phillips #00 screwdriver and take off the components.
Once all screws are removed, take out the barrel accessing the motherboard underneath.