2015 Jeep Patriot Tail/ Brake Light Replacement

Written By: Yadira Vera

Comments: 0

2015 Jeep Patriot Tail/ Brake Light Replacement

Difficulty

Moderate

Steps

Time Required

20 - 40 minutes

Introduction

To ensure the safety of drivers, it is vital to have functioning brake lights. If the brake lights on your 2015 Jeep Patriot aren't illuminating and need to be replaced, use this guide to replace the lightbulb.

The purpose of a tail/ brake light is to make your car visible during nighttime and heavy weather conditions and to communicate to the driver behind you that you are slowing down or stopping. A broken tail/ brake light is dangerous to yourself and the drivers around you. You could also get pulled over and receive a citation if your tail light is out.

Before beginning the repair, park in a safe location, turn the car off and put the emergency brake on.

Tools

Parts

SilverStar Mini Bulb 3157ST

Step 1

Open the trunk and locate the top rear bumper and fender fender clips.

Step 2

Use the 3/16 inch flathead screwdriver to remove the fender clips and two rear bumpers.

Step 3

Remove the rear bumper and fender clips on the bottom.

Step 4

Remove the tail light to expose the wires where the light bulbs are located.

Step 5

Twist the light bulb to remove it from the holder.
Replace the old bulb with the new one.
Don't touch the new light bulb with your bare hands as the oil from your fingers will cause it to degrade faster and possibly shatter.